High-country-tek DVC80 Bedienungsanleitung PDF herunterladen (Seite 48)

P/N: 021-00154, Rev. A.6 - updated for V4.7 Tools Page | 48

LED STATE MEANING

Off There is no power applied to the module.

On GREEN The module is operating in a normal condition.

Flashing GREEN Device is in standby state. May need servicing.

On RED Module has an unrecoverable fault.

Flashing RED Recoverable fault.

Flashing RED/Green This DVC7 was loaded with an application that was

compiled for a DCV10 or DVC5. The DVC7 is not

operational in this condition. Recompile the application

as a DVC7 type and load that application.

LED1 and LED2: Network Status

LED STATE MEANING

Off There is no J1939 device (or other DVCs) in the

project.

On GREEN J1939/CAN Bus communication has been established.

Flashing GREEN J1939/CAN Bus device in project but communication

has not been established. Flash 2 times in 2 seconds.

On RED The device has detected an error that has rendered it

incapable of communicating on the network.

Flashing RED The J1939 communication is in a timed-out state.

Flash 2 times in 2 seconds.

Normal Operation

Length: Until the next power cycle

Summary:

LED1 shows Network status

LED2 shows max PWM

LED3 error, System Enable or module ready

LED4 is the error code if any set by the blinkcode or open/short detection

LED1: Network Status (Same as Power On)

LED STATE MEANING

Off There is no J1939 device (or other DVCs) in the

project.

On GREEN J1939/CAN Bus communication has been established.

Flashing GREEN J1939/CAN Bus device in project but communication

has not been established. Flash 2 times in 2 seconds.

On RED The device has detected an error that has rendered it

incapable of communicating on the network.

Flashing RED The J1939 communication is in a timed-out state.

Flash 2 times in 2 seconds.

LED2: PWM Status

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 169 170

Keine Kommentare

High-country-tek DVC80 Bedienungsanleitung Seite 48